Take a hard look at load cells and get a head start on tighter process control

April 5, 2016  1243  1243   

Vishay Revere’s air–tight, water–tight story.

The hermetic seals that isolate the strain gage from the harsh outer world make a good starting point. Vishay Revere seals have been engineered and perfected to withstand severe environmental abuse. Users may not always have to work in a caustic atmosphere, but it is reasuring to know that Vishay Revere load cells can – even if users just want to hose things down once in a while.

Sealing actually takes place at two critical areas – where the strain gage and element are isolated, and where the cable is brought out of the load cell – and both require special attention. It’s industry norm for manufacturers to use potting or epoxy for the element seal. Epoxy may test hermetic but it can, over the long run, allow moisture to enter. Since long–run is the name of the game, Vishay Revere uses a precision, stainless–to–stainless weld for the element seal. The cable-exit seal requires a different approach, because it involves dissimilar materials. Here Vishay Revere provides an extra large, extra supportive compression seal to make sure users load cells will be as secure ten years hence, as it is on the day of installation.

Corrosion resistance that’s more than just skin deep.

The material that goes into the load cell is an important consideration, too. Again users may not be expecting their installation to take occasional acid baths, but its comforting to know that Vishay Revere’s load cells are even able to hold up to that eventuality.

Vishay Revere offers most of its load cells in solid stainless steel –a far cry from simple plating. These are not just the products they sell for harsh environments- Vishay Revere figure that replacing a load cell is something users shouldn’t have to think about more often than, say, every thirty or forty years.

Strain-gage bonding: dimensionless isolation.

It’s rare for load cell manufacturers to address the bonding of the strain gage into the cell. This is because the ideal is so easy to define: the strain gage should become an inseparable part of the metal surface, without losing its electrical isolation. Vishay Revere have spent a lot of time perfecting materials and bonding techniques, and the result is evident in the accuracy and repeatability. The result is evident in other ways, too: the better the bond, the longer users go on without losing calibration. Many of the Vishay Revere cells are still performing after 30 years in the field – and are still meeting spec! That is rare unless the bond is very close to ideal to begin with, and stays that way.

A last word about bonding: it’s a very special hand operation. Only Vishay Revere’s best people are bonders, and their Quality Assurance program puts  special emphasis on bonding techniques – thus ensuring they meet the highest standards. For more information on Vishay Revere’s load cells, contact Instrotech on 011 462 1920, sales@instrotech.co.za or visit www.instrotech.co.za